First Steps With The Dialooq C15; Charging The Battery Of The C15; Switching The C15 On - wow! DIALOOQ C15 Manual De Instrucciones

1. First steps with the DIALOOQ C15

These instructions guide you through the initial steps of using the DIALOOQ C15 diagnosis system.
Please refer to and comply with the notes and information in these instructions.

1.1 Charging the battery of the C15

The device has an internal battery, which must be fully charged before
the device is used for the first time.
1. Plug the small connector of the enclosed power pack into the DC-in
port "Fig.001" of the C15.
1
2. Plug the mains plug into a suitable power socket (100-240V AC
voltage).
Caution!
Risk of explosion
Use only the original power pack.

1.2 Switching the C15 on

1. Lift the display to open it.
2. Briefly press the On/Off button
the device.
If you press the On/Off button again, the device will go into power
saving mode.
ENG-8
"Fig.002" on the keyboard to start
2
1
Abb.001
Abb.002
WOW! DIALOOQ C15
2