Lionelo Bastiaan Manual Del Usuario página 11

4.
All safety seat belts must be tight, adapted to child's body and must not be twisted.
5.
All lap belts must be carried low so that the child's pelvis is properly supported.
6.
Buckles must be done up properly and securely. In case of emergency, a proper
assembly of buckles lets you take the child out of the safety seat easily.
7.
The device must be replaced if subject to rapid loads during accident.
8.
Do not modify the product in any way.
9.
Avoid situations in which the safety seat is exposed to direct sunlight.
Otherwise it may heat up and in effect cause the child to scald itself.
10. Do not leave the child in the safety seat unattended.
11. Make sure the luggage and other items which may lead to injuries in case
of accident have been secured.
12. Do not use the safety seat without material cover. Do not replace the cover
with other than recommended by the manufacturer. The cover is an integral
part of the safety seat.
13. The safety seat must be used in the car only.
14. It is forbidden to place any items on the child's safety seat.
15. Hard elements and plastic parts of the child holding device must be placed
and installed in a way that they are not trapped by a movable seat and vehicle
door during regular operation of the vehicle.
16. Before every travel, make sure the safety seat has been properly and securely
mounted.
17. During the travel, the safety seal must be properly attached to the car's
seat by means of the car safety belt or ISOFIX and Top Tether, even when
there is no child.
18. Do not use load bearing points of contact other than those described in the
instructions and marked on the child restraint
19. For rearward facing installation: do not install the child seat on seats with
airbags.
20. Install the rearward-facing seat if the child weighs less than 9 kg
CAUTION! Never use the safety seat with 2-point seat belts.
Fig. 1,2
Suitable position of the safety seat in the car
Not suitable position of the safety seat in the car
‑ 11 ‑ EN