Maintenance And Cleaning - Lionelo Bastiaan Manual Del Usuario

indicating a correct fixation. On both shoulders, the indicator should be green.
2.
Carry the car belt through the red guide on the headrest, and hip part through
the red guide beside the seat.
3.
Fasten the belt.
4.
Tighten the car belt.
5.
Make sure the shoulder part goes through the child's collarbone, not a neck.
The hip part must be positioned as low of the child's hip as possible.
6.
Adjust the headrest height.
If you are installing in cars without ISOFIX, skip the first point.
HOOD ASSEMBLY (fig. 25, 26)
1.
Pull the hood over the headrest of the seat
2.
Hook the mounting bands on plastic element of the headrest, as in the
picture below.

MAINTENANCE AND CLEANING

1.
Check for any damage to the safety seat on a regular basis. In case of any
irregularities, replace the safety seat immediately.
2.
Make sure the safety seat is not exposed to direct sunlight.
3.
Covers may be cleaned in warm water with a soap or a soft detergent. Do
not dry the covers in the sun.
4.
Clean a clasp, safety seat belts and plastic elements with warm water. Do
not use any detergents.
The product has been tested and meets all the requirements of the:
The pictures are for reference only. The real design of the products may differ from the
EN
ECE R44.04
pictures presented.
‑ 16 ‑