Assembly Procedure; Installation Requirements - Quick THG 1012 Manual Del Usuario

ASSEMBLY PROCEDURE:

below deck to perform the installation in the lower part. The thickness of deck must be such as to allow the capstan to be se-
curely placed in position.

INSTALLATION REQUIREMENTS:

per and lower surfaces of the deck are as parallel as possible.
If this is not the case, compensate the difference appropriate-
ly (a lack of parallelism could result in a loss of motor power).
The deck thickness must be included among the figures listed
in the table. In cases of other thicknesses it is necessary to
consult a Quick retailer.
®
ASSEMBLY:
when the ideal position has been established,
drill four holes using the drilling template provided.
Place the capstan and fasten it by screwing the nuts on the
fixing stud bolts. Connect the supply cables from the capstan
to the contactor unit.
Follow these steps to install the strap-roller on the sprocket:
Unscrew the screws (11) using a 6-mm Allen wrench; remove
the base plate (10) and pay attention to the pins (22) which
must be fitted back; unscrew and remove the screw (28).
Then fix the strap-roller by threading the screw (28) through the
end loop of the strap-roller.
Refit all the parts that were removed.
WARNING:
before wiring up, be sure the electrical
cables are not live.
THG 1000/1500W - REV001A
the following parts are to be checked before the holes are drilled. There must be no obstacles
ensure that the up-
INSTALLATION
28
STRAP-ROLLER
GB
10
22
11
11
11