Care And Cleaning; Exterior Surfaces; Metal Grease Filter; Charcoal Filter - GE UVW7241SNSS Manual Del Propietario E Instrucciones De Instalación

Care and Cleaning

IMPORTANT: Clean the hood and grease filters
frequently according to the following instructions. Replace
grease filters before operating hood.

EXTERIOR SURFACES:

To avoid damage to the exterior surface, do not use steel
wool or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
• Liquid detergent soap and water, or all-purpose
cleanser
• Wipe with damp soft cloth or nonabrasive sponge, then
rinse with clean water and wipe dry.

METAL GREASE FILTER

1. Push up on the middle, right side of the decorative
glass to open the door.
2. Remove the metal filter.
3. Wash metal filters as needed in dishwasher or hot
detergent solution.
4. Replace metal grease filters.
6

CHARCOAL FILTER

The charcoal filter is not washable. It should last up to 6
months with normal use.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See
"Metal Grease Filter" in this section.
2. Bend spring clips away from metal grease filter.
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the
charcoal filter to the metal filter.
5. Replace metal grease filter. See "Metal Grease Filter"
in this section.

REPLACING A LAMP

Turn off the range hood and allow the lamp to cool. To
avoid damage or decreasing the life of the new bulb, do
not touch bulb with bare fingers. Replace bulb, using
tissue or wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are
inserted correctly before calling service.
1. Disconnect power.
2. Use a flat-blade screwdriver to pry open the light cover.
3. Avoiding contact with skin, replace the used bulb with
a new halogen bulb, of the same size, shape and
wattage.
4. Replace the light shield and snap closed.
5. Reconnect power.
49-2000742 Rev. 0