Installation Preparation - GE UVW7241SNSS Manual Del Propietario E Instrucciones De Instalación

PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and
ordinances.
Have a qualified technician install the range hood. It is
the installer's responsibility to comply with installation
clearances specified on the model/serial rating plate.
The model/serial rating plate is located behind the left
filter on the rear wall of the vent hood.
Canopy hood location should be away from strong
draft areas, such as windows, doors and strong
heating vents.
Grounded electrical outlet is required. See "Electrical
Requirements" section.
The canopy hood is factory set for venting through the
roof or wall. For non-vented (recirculating) Installation
see "For non- vented (recirculating) installation only" in
the "Connect Vent System" section.
All openings in ceiling and wall where canopy hood will
be installed must be sealed.
8

Installation Preparation

FOR MOBILE HOME INSTALLATIONS
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards,
Title 24 CFR, Part 328 (formerly the Federal
Standard for Mobile Home Construction and Safety,
Title 24, HUD, Part 280) or when such standard
is not applicable, the standard for Manufactured
Home Installation 1982 (Manufactured Home Sites,
Communities and Setups) ANSI A225.1/NFPA 501A,
or latest edition, or with local codes.
49-2000742 Rev. 0