Connect Vent System; Make Electrical Connection; Complete Installation - GE UVW7241SNSS Manual Del Propietario E Instrucciones De Instalación

CONNECT VENT SYSTEM

For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover
bracket with 4 - assembly screws provided with
the Recirculation Kit.
Duct Cover Bracket
2. Measure from the bottom of the air deflector to
the bottom of the hood outlet.
Vent
Clamp
Vent
Duct
Exhaust
Outlet
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over
the exhaust outlet from the hood.
7. Reassemble the air deflector to the duct cover
bracket with 4 assembly screws.
8. Seal connections with vent clamps.
12
Installation
Assembly Screws
Air Deflector
Air Deflector
X = length to
cut vent duct

MAKE ELECTRICAL CONNECTION

WARNING
ELECTRICAL SHOCK
HAZARD
Plug into a grounded 3-prong outlet
Do not remove the ground prong
Do not use an adapter
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Plug into a grounded 3-prong outlet.

COMPLETE INSTALLATION

1. For non-vented (recirculating) installations only,
install charcoal filters over metal grease filter. See
the Care and Cleaning section.
2. Install metal filters. See the Care and Cleaning
section.
3. Check the operation of the range hood blower
and light. See the Using the Hood section.
NOTE: To get the most efficient use from your new
range hood, read the Using the Hood section.
49-2000742 Rev. 0