Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND POWER
SUPPLY
Note:
Keeping back up batteries inside the compartment prevent
stored data in preset memories from being lost.
Back up battery installation (Fig. 2)
1. Pull out the battery compartment locker to release
battery compartment. There are main battery pack
compartment and back up battery compartment.
2. Remove back up battery compartment cover and insert
2 fresh UM-3 (AA sizes). Make sure the batteries are
with correct polarity as shown inside the compartment.
Replace the battery cover.
3. After back up batteries are inserted, insert the main
battery pack to power radio. The suitable battery packs
for this radio listed as the following table.
The following tables indicate the operating time on a
single charge.
Installing or removing Slide battery
cartridge (Fig. 3 & 4)
● Always switch off the tool before installing or removing
of the battery cartridge.
● Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge.
● To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
● If you can see the red indicator on the upper side of the
button, it is not locked completely. Install it fully until the
red indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
● Do not use force when installing the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge or
pressing the buttons on both sides of the cartridge.
Return the battery compartment locker to the original
position.
Reduced power, distortion and a "stuttering sound" or low
battery sign
that appears on the display are all the
signs that the main battery pack needs to replace.
Note:
The battery pack can't be charged via the supplied AC
power adaptor.
When low battery sign
flashing is the time to replace the back up batteries.
appears and an "E" keeps on
Indicating the remaining battery
capacity (Fig. 5)
1. Indicator lamps
Only for battery cartridges with "B" at the end of the
model number
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator or lamps
Lighted
015658
Note:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
● The first(far left) indicator lamp will brink when the
battery protection system works.
Installing the soft bended rod antenna
(Fig. 2 & 6)
Install the soft bended rod antenna as shown in the figure.
Note:
There is a click in the battery compartment designed to
store the removed antenna.
Using Supplied AC power adaptor
(Fig. 7)
Remove the rubber protector and insert the adaptor plug
into the DC socket on the front side of the radio. Plug the
adaptor into a standard mains socket outlet. Whenever
the adaptor is used, the battery pack is automatically
disconnected. The AC adaptor should be disconnected
from the main supply when not in use.
Note:
When your radio has any interference in AM band by its
adaptor, please move your radio away from its AC adaptor
over 30cm.
7 ENGLISH
2. Check button
Remaining capacity
Off
Blinking
Charge the battery
The battery may
have malfunctioned
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Publicidad
Tabla de contenido
