Noise Information; Component List; Vibration Information; Technical Data - Worx WG261E Manual De Instrucciones

Wear protective gloves.
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.

COMPONENT LIST

1. BATTERY PACK RELEASE BUTTON*
2. BATTERY PACK*
3. REAR HANDLE
4. FRONT HANDLE
5. SAFETY GUARD
6. FRONT SWITCH LEVER (ALL AROUND SWITCH
FUNCTION)
7. REAR SWITCH LEVER
8. BLADE
9. BLADE SHEATH
*Not all the accessories illustrated or described are
included in standard delivery.

TECHNICAL DATA

Type Designation: WG261E WG261E.1 WG261E.9 (230-
269- designation of machinery, representative of
cordless hedge trimmer)
WG261E/
WG261E.1
Voltage
Power
No load speed
Max. cutting length
Cutting diameter
Charging
time(WG261E)
Charging
time(WG261E.1)
Cordless Hedge Trimmer
WG261E.9
220-240V~50/60Hz
20V Max** Lithium
2200/min
45cm
16mm
58 mins
230 mins
Machine Weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage is
18 volts.

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
Wear ear protection

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value: a
Uncertainty K = 1.5m/s2
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool is
used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating cycle
such as the times when the tool is switched off and when
it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
2.4 kg 2.0 kg
L : 69.6dB(A)
pA
K = 3 dB(A)
pA
L : 82.45dB(A)
wA
K = 3 dB(A)
wA
2
= 2.2m/s
h
EN
9