Assembly & Operation - Worx WG261E Manual De Instrucciones

Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
ACCESSORY
Blade sheath
Safety guard
Charger 1 (WA3880)
Battery pack 1 (WA3551)
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
10
book carefully.
Intended use
The machine is intended for cutting and trimming hedges
and bushes in domestic use.
WARNING! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Loosen the long screw first before
assembling the front handle.
NOTE: If the handle is assembled
incorrectly, the tool will not power on.
Checking the battery charge condition (Only
for WG261E)
Installing and Removing the battery pack
Cordless Hedge Trimmer
WG261E WG261E.1
1 1
1 1
1 (WA3760)
2 (WA3550.1)
FIGURE
See Fig. A
See Fig. B1,
B2, B3
See Fig. C
See Fig. D
Charging the battery pack
Your battery pack is UNCHARGED, you must
charge before use.
More details can be found in WA3760/
WA3880 manual
OPERATION
Starting and stopping
Top cutting
WARNING: If any parts are missing,
WG261E.9
damaged or broken, do not operate
your hedge trimmer until all damaged parts
1
have been replaced or repaired. Failure to
do so could result in serious personal injury.
1
DO NOT USE WITHOUT FRONT HANDLE AND
SAFETY GUARD.
/
Side cutting
/
Lubricating the Cutting Blade
NOTE: It is important to use only the
recommended standard lubricating oil (WD-
40) to avoid damage to the blade.
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be activated on three
sides, giving you many choices for a comfortable grip.
Before cutting an area, inspect it first and remove any
foreign objects that could become thrown or entangled
in the blades. Always hold the trimmer with both hands
and with the blade away from you before turning it on.
When trimming new growth, use a wide sweeping action
so that the stems are fed directly into the blade. (See
Fig. F1&F2)
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades away
from people and objects such as walls, large stones,
trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer. Release
the two Switch components (6&7) before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. F1). A slight
downward tilt of the cutting blades in the direction of
motion gives the best cutting results.
SIDE CUTTING
When trimming the sides of the hedge, begin at the
bottom and cut upwards (See Fig. F2), tapering the
hedge inward at the top. This shape will expose more of
the hedge, resulting in a more uniformed growth.
See Fig.
E1, E2
See Fig. F1
See Fig. F2
See Fig. G
EN