Functional Description - Makita BLM381 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

Installing or removing battery cartridge
CAUTION:
Always switch off the tool before installing or
•
removing the battery cartridge.
Make sure that you lock the battery cover before
•
use. Otherwise, mud, dirt, or water may cause
damage to the product or the battery cartridge.
Always install the battery cartridge fully until the
•
red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to
you or someone around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
To install the battery cartridge;
1. Pull the battery cover locking lever toward
yourself and open the battery cover.
1
2
014484
2. To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
1
2
014616
3. Insert the lock key in the place shown in the
figure as far as it will go.
1. Battery cover
locking lever
2. Battery cover
1. Battery cover
2. Battery cartridge
5
2
014617
4. Close the battery cover and push it on until it is
latched with the locking lever.
To remove the battery cartridge from the mower;
1. Pull the battery cover locking lever toward
yourself and open the battery cover.
2. Slide it from the tool while sliding the button on
the front of the cartridge.
3. Pull out the lock key.
4. Close the battery cover.
Battery protection system
Lithium-ion batteries are equipped with a protection
system. This system automatically cuts off power to the
tool to extend battery life.
The tool will automatically stop during operation if the
tool and/or battery are placed under one of the following
conditions:
Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this situation, release the trigger switch on
the tool and stop the application that caused
the tool to become overloaded. Then pull the
trigger switch again to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before pulling the trigger switch again.
Low battery voltage:
•
The remaining battery capacity is too low
and the tool will not operate. In this situation,
remove and recharge the battery.
Battery remaining capacity indicator
(only for models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
1 1. Battery cartridge
2. Lock key
1. Indicator lamps
2. CHECK button