Adjusting The Mowing Height - Makita BLM381 Manual De Instrucciones

Ocultar thumbs Ver también para BLM381:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light
for approx. three seconds.
Indicator lamps
Lighted
Off
Blinking
E
011713
When only the lowermost indicator lamp (next to
the "E") blinks, or when none of the indicator
lamps light, the battery capacity has run out, so
the tool does not operate. In these cases, charge
the battery or replace the empty battery with a fully
charged one.
When two or more indicator lamps do not light
even after charging is complete, the battery has
reached the end of its service life.
When the upper two and lower two indicator lamps
light
alternately,
malfunctioned.
authorized service center.
NOTE:
The indicated capacity may be lower than the actual
level during use or immediately after using the tool.
Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Power switch action
WARNING:
Before installing the battery cartridge in the
tool, always check to see that the switch lever
actuates properly and returns to the original
position when released. Operating a tool with a
switch that does not actuate properly can lead to
loss of control and serious personal injury.
NOTE:
Trying to mow much grass at a time may not allow
the motor to start due to the overload. At this time,
change the mowing height to higher level to restart.
The mower does not start without pressing the
switch button even if the switch lever is pulled.
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
the
battery
may
Contact
your
local
This mower is equipped with the interlock switch and
handle switch. If you notice anything unusual with either
of these switches, stop operation immediately and have
them checked by your nearest Makita Authorized or
Factory Service Center.
2
014617
1.
Install the battery cartridge. Insert the lock key
into the interlock switch and then close the
battery cover.
1
014488
2.
Press the switch button.
3.
Pull the switch lever toward you while pressing
have
the switch button.
Makita
4.
Release the switch button as soon as the motor
starts running. The mower will continue to run
until you release the switch lever.
5.
Release the switch lever to stop the motor.
6.
When not in use, remove the lock key. Store the
lock key in a safe place out of reach of children.

Adjusting the mowing height

WARNING:
Never put your hand or leg under the mower unit
when adjusting the mowing height.
Always make sure that the lever fits in the groove
properly before operation.
014486
6
1
1. Battery cartridge
2. Lock key
1. Switch button
2
2. Switch lever
1. Mowing height
2
adjusting lever
B
2. Pins
A
1

Publicidad

Tabla de contenido
loading

Tabla de contenido