Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
4
2
3
014480
3.
Raise the upper handle and align the screw holes
in the upper handle with those in the lower handle.
Secure them with the supplied screws, curl
washers and clamping nuts.
NOTE:
At this time, keep a firm grip on the upper handle
•
so that it does not drop off your hand.
1
3
014481
NOTE:
Install the upper handle so that the direction of the
•
upper handle and the power supply cord are
positioned as shown in the figure.
Removing or installing the blade
WARNING:
Always remove the lock key and battery cartridge
•
when removing or installing the blade. Failure to
remove the lock key and battery cartridge may
cause a serious injury.
The blade coasts for a few seconds after releasing
•
the switch. Make sure that the blade has come to
a complete stop.
Always wear gloves when handling the blade.
•
1
3
2
014543
1.
Put the mower on its side so that the mowing
height adjusting lever is placed on the upper side.
1. Clamping nut
2. Curl washer
3. Screw
4. Tighten
4
1. Holder
2
2. Upper handle
3. Cord
1. Blade
2. Box wrench
3. Loosen
4. Lumber
4
2.
To lock the blade, insert a lumber or similar into
the mower.
3.
Loosen the bolt counterclockwise with the box wrench.
3
5
014499
4.
Remove the bolt, spring washer, flat washer, and
blade in order.
To install the blade, take the blade removal procedure in
reverse.
WARNING:
Install blade carefully as they have a top/bottom facing.
•
Tighten the bolt clockwise firmly to secure the
•
blade.
Put the blade so that the blade side with a
•
rotational direction arrow faces outward.
Make sure that the blade is installed securely.
•
Installing the grass basket
Remove the lock key.
014545
Raise the rear guard of the mower unit.
1. Groove
2. Hook
3. Grass basket
014544
Hook the grass basket on the groove of the mower unit.
8
1. Blade support
2. Blade
1
3. Flat washer
4. Spring washer
5. Bolt
2
4
2
3
1
Publicidad
Tabla de contenido
