Publicidad
Idiomas disponibles
Idiomas disponibles
Table of Contents
Table des matières - Indice
English .........................................
Français .........................................
Español .........................................
All manuals and user guides at all-guides.com
1
6
12
Disclaimer
This manual is intended only as a guide for Antec's Computer Enclosures. For more
comprehensive instructions on installing your motherboard and peripherals, please refer
to the user's manuals which come with your components and drives.
SX800II Series - Workstation Tower Case
The power supply comes with a main power switch. Make sure you turn the switch to the
ON ( I ) position before you boot up your computer for the first time. In normal operation
there is no need to turn the switch to the OFF (O) position since the power supply is
equipped with a soft on/off feature which turns your computer on and off through the soft
switch on your computer case. You may need to turn the switch to the OFF position
occasionally should your computer crash and you cannot shut it down through use of the
soft switch.
Set Up
1.
Take the case out of the box.
2.
Remove the Styrofoam.
3.
Remove the plastic bag.
4.
Place the case upright on a stable flat surface with the power supply fan at the back
facing you .
5.
Remove the screws from the side panel with the latch, unlatch the panel, and swing it
out to remove.
Note: Please doesn't try to use your fingernails to pry or lift the panels.
6.
Inside the case you should see the power supply, some wiring with marked connectors
(USB, IEEE1394, PWR etc.), an installed I/O panel, a power cord and a plastic bag
containing more hardware (screws, brass standoffs, plastic stands, etc.), and six Drive
Rails.
Motherboard Installation
This manual is not designed to cover CPU, RAM, or expansion card installation. Please
consult your motherboard manual for specific mounting instructions and troubleshooting.
1.
Lay the case down so that the open side is up. You should be able to see the drive
cage and power supply.
2.
Make sure you have the appropriate I/O panel for your motherboard. If the panel
provided is not suitable for your motherboard, please contact your motherboard
manufacturer for the correct I/O panel.
3.
Line up motherboard with the standoff holes, determine which ones line up, and
remember where they are. Not all motherboards will match with all of the provided
screw holes, and this is not necessary for proper functionality. (In other words there
will likely be extra holes.) Some standoffs may be pre-installed for your convenience.
4.
Lift up and remove your motherboard.
5.
Screw in the brass standoffs to the threaded holes that line up with your motherboard.
6.
Place your motherboard on the brass standoffs.
7.
Screw in your motherboard to the standoffs with the provided metallic Phillips-head
screws.
8.
Your motherboard is now installed.
1
Publicidad
