Normal Measurement - A&D Medical UA-651BLE Manual De Instrucciones

Taking your Blood Pressure

Normal Measurement

1. Place the cuff on the arm (preferably
the left arm). Sit quietly during
measurement.
2. Press the START button. All of the
display segments are displayed.
Zero is displayed blinking briefly.
Then the display changes, as
indicated in the figure to the right,
as the measurement begins. The
cuff starts to inflate. It is normal for
the cuff to feel very tight. A pressure
bar indicator is displayed, as in the
figure to the right, during inflation.
Note: If you wish to stop inflation at any time, press
the START button again.
3. When inflation is complete,
deflation starts automatically
and the (heart mark) blinks,
indicating that the measurement
is in progress. Once the pulse is
detected, the mark blinks with each
pulse beat.
Note: If an appropriate pressure is not obtained, the
device starts to inflate again automatically.
4. When the measurement is
complete, the systolic and diastolic
pressure readings and pulse rate
are displayed. The cuff exhausts the
remaining air and deflates completely.
5. Press the START button again to turn off the power.
Note: This product is provided with an automatic power shut-off function, which turns the power
off approximately one minute after measurement.
At heart level
Press the START button
All of the display
segments
Zero display
Starts in ation
Pressurizing
Turn o with the
START button
E-18