Reactive Forces - Stihl HTA 66 Manual De Instrucciones

English
ger be in a safe condition. This may result in
serious injury to people and damage to prop‐
erty.
► Stop working, remove the battery and con‐
sult a STIHL servicing dealer.
■ Vibrations may occur while using the pole pru‐
ner.
► Wear gloves.
► Take breaks.
► If signs of a circulatory disturbance occur:
Consult a doctor.
■ If the moving saw chain hits a hard object,
sparks may occur. Sparks can cause fires in a
flammable environment. Persons may be seri‐
ously or fatally injured and property may be
damaged.
► Do not use the chain saw in a flammable
environment.
■ The saw chain runs on for a short period after
you release the trigger. People may be cut by
the moving saw chain. They may cause seri‐
ous injury to persons.
► Hold the pole pruner firmly with both hands
and wait until the saw chain comes to a
standstill.
■ In an emergency, the user may start to panic
and forget to take off the carrying system. This
may result in serious injury to the user.
► Practice taking off the carrying system.
WARNING
B
2
If you saw wood which is under tension, the
■
guide bar may become jammed. The user may
lose control of the pole pruner and be seri‐
ously injured.
► First make a relief cut (1) on the compres‐
sion side (A), then a separating cut (2), off‐
set in the direction of the trunk, on the ten‐
sion side (B).
DANGER
■ Working near live electric cables may result in
accidental contact with the saw chain and
36
1
A
damage the cables. This may result in serious
or fatal injury to the user.
► Maintain a clearance of 15 meters
from live cables.
4.7.2 Limbing
WARNING
■ During delimbing the sawn-off branch may fall
to the ground. This may result in serious injury
to the user.
► Do not stand under the branch which you
are sawing.
► Maintain an angle of no more than 60° to
the horizontal.
4.8

Reactive Forces

4.8.1 Kickback
Kickback can be caused for the following rea‐
sons:
– The rotating saw chain in the upper quadrant
of the bar nose makes contact with a hard
object and is suddenly braked.
– The rotating saw chain is pinched at the bar
nose.
4 Safety Precautions
max 60°
0458-191-9821-B