Andis RT-1 Instrucciones De Uso Y Cuidado página 3

damaged, or dropped into water. Return the appliance to an
Andis authorized service station for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.
8. Do not use this appliance with a damaged or broken blade
or comb, as injury to the skin may occur.
9. To disconnect turn control to "off" then remove plug from
outlet.
SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE
OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.
Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or
as noted on the unit. To start trimmer, move ON/OFF switch button to ON position,
to stop, move switch button back to original position.
ATTACHING THE TRIMMER COMBS
(Some models do not come with attachment combs)
To attach trimmer combs, slide front of comb over the teeth of the blade (Figure A).
Snap comb down over back of blade until comb snaps into place (Figure B). Combs
help guide hair to cutting blades and give you precise control of hair lengths. Each
comb allows a different length of cut which is indicated on the combs. Use the chart
on page 5 to find the approximate lengths of cut. Different blade angles in relation
to the skin, thickness and texture of the hair will vary the cutting length.
3