Andis RT-1 Instrucciones De Uso Y Cuidado página 6

Place a few drops of Andis Clipper Oil on the front and side of the cutter blades
(Figure J). Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain
insufficient oil for good lubrication, but are an excellent clipper blade coolant. Always
replace broken or nicked blades to prevent injury. You can clean the excess hair from
your blades by using a small brush or worn out toothbrush. To clean the blades we
suggest to immerse the blades only into a shallow pan of Andis Blade Care Plus,
while the trimmer is running. Any excess hair and dirt that has accumulated between
the blades should come out. After cleaning, turn your trimmer off and dry blades
with a dry cloth and start clipping again.
CLEANING THE SHAVER HEAD
Regular cleaning is necessary in order to maintain the optimal performance and
maximum comfort when shaving:
1. Switch the trimmer off. Remove the shaver head (Figure G).
2. Run the shaver head under cold or lukewarm water. Do not run the trimmer
under water.
3. Dry the shaver head with a soft cloth and attach it back onto trimmer, making sure
it snaps into place.
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper/trimmer become dull after repeated use, it is
advised to purchase a new set of blades available through your Andis supplier. Some
blade sets can be resharpened – contact your Andis supplier or the Andis Company
for information on resharpening. If you wish your clipper/trimmer to be serviced as
well, contact your Andis supplier. If you have a problem contacting your Andis
supplier, contact the Andis Company customer service department at
1-800-558-9441 or email at info@andisco.com.
CAUTION: Never handle your Andis trimmer while you are operating a water
faucet, and never hold your clipper under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. Andis Company will not
be responsible in case of injury due to this carelessness.
6