Wilo PB BOOST FIRST Instrucciones De Instalación Y Funcionamiento página 21

Installation and operating instructions Wilo-PB BOOST FIRST
Product delivered with Wilo-Connector (W ver-
sion)
ƒ
If the product is supplied with a connector, the
minimum cross-section of the power cord must
be 3 x 0.75 mm² and its properties must be at
least: standard polychloroprene coated (60245
IEC 57).
Installing Wilo-Connector
ƒ
Disconnect the connecting cable from the
power supply.
ƒ
Observe terminal assignment (PE, N, L).
ƒ
Connect and install the Wilo-Connector (Fig. 9a
to 9e).
Connecting the pump
ƒ
Earth the pump
ƒ
Connect Wilo-Connector (12) to the connec-
tion cable (11) until it snaps into place (Fig. 9f).
removing the Wilo-Connector
ƒ
Disconnect the connecting cable from the
power supply.
ƒ
Remove the Wilo-Connector using a suitable
screw-driver (Fig. 9g).
en
21