DHC BT2400 Manual Del Propietário página 10

<<SURFACE CHARGE>>
*Note that if the BT2400 detects the surface charge. The BT2400 will pop up a
notification to ask the user to turn on loads / headlights for 15 seconds to
eliminate the surface charge.
If the BT2400 keeps popping up the notification of "Turn on loads & headlights for
15seconds", it might because of the vehicle is equipped with the latest LED
headlights & modern vehicle control modules. Turn on loads & headlights for 15
seconds on these vehicles might not be enough to eliminate the surface charge.
Please select "NO" to the "Battery Test In Vehicle Setting" to skip the surface
charge detection and carry on the test. (Refer to 6V & 12V Battery test item 7.)
BATTERY TEST RESULTS
1. GOOD & PASS
The battery is good and capable of holding a charge.
2. GOOD & RECHARGE
The battery is good but needs to be recharged.
3. CAUTION
The battery may be serviced but decrease the capability of starting the
engine gradually. The battery may fail under extreme climate conditions.
There may be a poor connection between the vehicle and the battery
affect the charging function. Please pay attention to the battery for
replacement consideration and charging system checking.
4. RECHARGE & RETEST
Battery is discharged, the battery condition cannot be determined until it
is fully charged. Recharge & retest the battery
5. BAD & REPLACE
The battery will not hold a charge. It should be replaced immediately.
6. BAD CELL & REPLACE
The battery has at least one cell short circuit. It should be replaced
immediately
7. LOAD ERROR
The tested battery is bigger than 3000CCA/SAE or the clamps are not
connected properly. Please fully charge the battery and retest after
excluding both previous reasons. If reading is the same, the battery
should be replaced immediately.
10