DHC BT2400 Manual Del Propietário página 17

DC/AC Current measurement
1. Install the 9V battery.
2. Connect Clamp Meter to the jack A on BT2400
3. Press the button ZERO. Make sure the display reads zero.
4. Press the trigger to open the transformer jaws and clamp one electrical
wire.
5. Make sure the clamp jaw is perfectly closed.
6. Select V/A METERS from the main menu.
7. Read the displayed value.
8. select "Record Max" and then select "Stop Recording", the BT2400 will
display the max current recorded durging the recoding period.
DC Voltage Measurements
*Do not test more than 60V, it may damage the tester.
1. Connect Red Test Lead to the jack V on BT2400
2. Use the test lead to touch a point within the network of the battery.
3. Select V/A METERS from the main menu.
4. Read the displayed value.
5. select "Record Max" and then select "Stop Recording", the BT2400 will
display the max voltage recorded durging the recoding period.
Battery System
Test
V/A
Setting
Meters
IR
Test
Test
History
V/A
Meters
<<Record MAX>>
17
Voltmeter
--.--V
Ammeter
--- A