Kohler K-3588 Guia De Instalacion página 5

Waste Tube
Outlet
Gasket
Waste Stack
2. Mark the Installation
Remove the gasket from the waste tube.
Tilt the toilet, attach the 4" D. waste tube, and move the toilet
into the installation position. The waste tube and waste outlet
should be engaged.
IMPORTANT! If there is a flange and the floor flange sits above the
finished floor, check for proper fit with the base of the toilet. If the
base of the toilet does not fit over the floor flange you will need to
cut or grind (depending upon the flange material) the flange to
allow the toilet to install properly.
Make sure there is a 1" (2.5 cm) gap between the back of the toilet
and the wall.
IMPORTANT! Make sure the toilet is correctly positioned before
marking installation location.
Trace the base of the bowl on the floor.
Remove the waste tube and toilet, and set aside.
Cut the template along the outside line with a scissors.
Kohler Co.
Remove gasket when
dry fitting toilet.
Front of
Bowl
1"
(2.5 cm)
Waste
Stack
Orientation of flange may vary.
5
Notch
flange
here.
1095641-2-B