Publicidad
Idiomas disponibles
Idiomas disponibles
5. FITTING THE HANDLEBAR.-
Fit the handlebar (57) onto the front post. Fit the
screws (64) and the washers (65), Fig.6.
Move the lower tray (139) up, attach the upper tray
(138) and fix the trays using the joints (136) and the
screws (130), (131), Fig.7.
6. FITTING THE MONITOR.-
Remove the back monitor cover. Remove the screws
of the back plate of the monitor. Attach the front cover
(133), Fig.8.
Place the monitor (58) onto the front post plate as
shown in Fig.8 and refit the screws.
Connect the terminals coming out of the front post and
of the monitor.
Refit the back monitor cover (37) with the screws (38),
Fig.9.
Attach the back cover (132) using the screws (130),
(131), Fig.9.
7. FITTING THE SADDLE PROFILE.-
Firstly remove the screws (28) of the saddle (96),
Fig.10. Attach the saddle (96) to the support and refit
the screws (28), Fig.10.
Place the saddle profile (79) close to the main body
(1) and connect terminal from saddle profile.
Afterwards introduce tube of main body in aluminium
profile, Fig.10A, paying special attention to the cables.
Insert the head of the screws in the slots of the rail
and tighten the nuts (84), Fig.10A.
Fit the trim (74), Fig.10. Finally, place screw (75) and
tighten securely.
8. ATTACHING THE BACKREST.-
Attach the backrest (145), as shown in Fig.11, insert
the screws (64) and the washers (65) and tighten
securely.
Attach the back cover (146) using the screws (144).
MOD. H775RBM
9. LEVELLING.-
Once the unit has been placed into its final position,
make sure that it sits flat on the floor and that it is
level. This can be achieved by screwing the
adjustable feet (70) up or down, as shown in Fig.12.
To level the seat:
Loosen the screws (84) under the rail. Level seating
position with the screws (108). Tighten the screws
(84) again
Fig.12A.
10.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (67) to make it
easier to move. The wheels located at the front of
your unit make it easier to move it into a chosen
position, by lifting the rear of the unit up slightly and
pushing it, as shown in Fig.13. Store your unit in a dry
place,
preferably
temperature.
11.
MAINS CONNECTION.-
Insert the jack (g) on the transformer (97) into the
connection hole (h) on the main body (1) (bottom, rear
of the machine) and then plug the transformer into a
230 V mains supply, Fig.14.
Do not hesitate to get touch with the Technical
Assistance Service if you have any queries by phoning
customer services (see last page in manual)
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE
13
not
subject
to
changes
in
Publicidad
