Kohler PRO 3.7 Manual Del Usuario página 8

2.10.6 GFCI Receptacle
To reduce chance of electrical shock:
1. Do not attempt to operate equipment if ground fault circuit interrupter (GFCI) RESET button pops out repeatedly
during use.
2. Remember that only receptacles labeled GFCI have ground fault circuit interrupter protection. Ground Fault Circuit
Interrupter (GFCI) stops power to protected receptacles (A11) if a ground fault (electrical leak) is detected. If RESET
button pops out, equipment plugged into receptacle (A11) may be faulty. If this happens, check equipment carefully. If
equipment appears to be in good condition, press RESET button firmly until a click is heard. This will restore power. If
RESET button pops out again, unplug equipment immediately. Contact a Kohler portable dealer before attempting to
use it again.
Follow below steps to perform GFCI Receptacle Test:
1. Start engine.
2. Press TEST button, if functioning properly RESET button should pop out, stopping power to outlet.
3. If GFCI operation is correct, push RESET button in. If GFCI operates incorrectly, contact a Kohler portable dealer.
3.1 Key to Illustrations
The cover illustrations can be used to identify the various components of the unit. The procedures in the manual refer to these
illustrations using letters and numbers as identifiers: "A1" refers to the number 1 on figure A.
Earth Terminal
Oil Dipstick/Filler Plug
Fuel Level Indicator
Fuel Tank Cap
Fuel Valve
Air Filter
Engine On/Off Switch
Choke Lever
Starter Recoil Reel
Handle
Oil Drain Plug
GFCI Receptacle
Fuel Filter
Power Selector Switch
3.2 Initial Commissioning
On taking delivery and commissioning the unit:
1. Check that it is complete and not damaged in any way.
2. If the unit is fitted with a transport bracket, remove it.
The transport bracket is a metal plate located underneath the engine, close to the earth terminal.
Although useful for transportation, it will prevent optimum operation of the unit (noise, vibration).
To remove it: lift the unit slightly and place it on a block then remove the nut (1) and the clamp (2).
3. Check the oil and fuel levels and top them up if necessary.
4. If necessary, connect the battery, starting with the positive terminal.
Observe the polarity of the battery terminals when connecting it: as this could cause serious damage to the electrical equipment.
Some units require a running-in period. Contact your nearest dealer for more information.
Low permeation fuel line must be installed on carbureted Kohler Co. engines to maintain EPA and CARB regulatory compliance.
4
A1 Exhaust Silencer
A2-B1 Spark Plug
CO Sensor Indicator
A3
Light
A4 Circuit Breaker
A5 Change Oil Light
Replace Air
A6
Light
Replace Spark Plug
A7
Light
Low Oil Indicator
A8
Light
A9 Reset
A10-B5 Maintenance Minder
120/240V/30A
A11
Electrical Socket
120V/30A Electrical
A12
Socket
A13
Section 3. Getting Started with the Generator Set
A14 Circuit Protector
A15-E2 Filler Neck
A16 Dipstick Upper Limit
A17 Dipstick Lower Limit
A18 Air Filter Cover Screw
Filter
A19 Air Filter Cover
A20 Foam Element
A21 Air Filter Base
A22 Spark Arrester
Spark Arrester Mounting
A23
Bolt
Exhaust
A24
Protection
A25 Spark Plug Cap
A26
B2
B3
B4
C1
C2
C3
C4
D1
D2
Silencer
D3
E1
1
2
TP-7213 7/21