Bluetooth Pairing - THOMSON WHP-6005BT Manual De Instrucciones

• Once the charging process is complete, the indicator
LED goes out.
• Disconnect all cable and mains connections after use.
5. Operation

5.1 Bluetooth pairing

Note – Pairing
• Make sure that your Bluetooth-capable terminal
device is on and Bluetooth is activated.
• Make sure that your Bluetooth-capable terminal
device is visible for other Bluetooth devices.
• For more information, please refer to the operating
instructions of your terminal device.
• The headset and the terminal device should be no
further than 1 metre apart. The shorter the distance,
the better.
• Make sure that the headset is fully charged and
switched off.
• Press and hold the multifunction button (1) for about 6
seconds to turn the headset on. It automatically enters
pairing mode. The white and blue indicator lights flash
alternately. The headset is searching for a Bluetooth
connection.
• Open the Bluetooth settings on your terminal device
and wait until "6005BT" appears in the list of Blue-
tooth devices found.
• Select "6005BT" and wait until the headset is listed as
connected in the Bluetooth settings on your terminal
device.
Note – Bluetooth password
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your terminal device requests a password for
connection to the headset, enter 0000.
All manuals and user guides at all-guides.com
• You can now use the headset.
5.2. Automatic Bluetooth connection (after
successful pairing)
• Make sure that the headset is switched on.
• Press the multifunction button (1) to automatically
• You can now use the headset.
Note
• If pairing was successful, the display flashes quickly
in blue ten times and then flashes once every 6
seconds.
• If pairing was not successful, the display remains
permanently illuminated, and you will have to
perform pairing again.
• The display will go out if pairing takes longer than
60 seconds.
• If this happens, you will need to switch the headset
off and on again if you want to pair it with your
terminal device again.
connect the headset with your terminal device.
Note – Connection impaired
If the Bluetooth connection is not established
automatically, check the following:
• Check the Bluetooth settings of your terminal
device to see whether "6005BT" is connected. If
not, repeat the steps listed under 5.1. Bluetooth
pairing.
• Check whether obstacles are impairing the range. If
so, move the devices closer together.
• The performance can also be affected by a weak
battery.
3