Audio Playback; Hands-Free Function - THOMSON WHP-6005BT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16

5.3. Audio playback

Note
• Note that the functions described under 5.3. and
5.4. are only possible with an active Bluetooth
connection.
• Your terminal device must also support the
individual functions (in particular, it must support
Bluetooth profiles).
• For more information, please refer to the operating
instructions of your terminal device.
• Functions can still be controlled directly via the
terminal device.
• Set the volume on your terminal device to a low level.
• Start audio playback on the connected terminal device.
• Press the multifunction button (1) to start or pause
audio playback.
• Press and hold the + button (2) for about 2 seconds to
skip to the next title.
• Press and hold the – button (2) for about 2 seconds to
skip to the previous title.
• Press the – button (2) to reduce the volume.
• Press the + button (2) to increase the volume.

5.4 Hands-free function

You can use the headset as a hands-free set for your
mobile phone if your terminal device supports it.
Accept:
Press the multifunction button (1) once to answer an
incoming call.
Hang up:
To end the call, press the multifunction button (1) once
more.
Reject:
Press and hold the multifunction button (1) for about 2
seconds to reject an incoming call.
Redial:
While the headset is connected to your mobile phone
and in standby mode, press the multifunction button
twice to redial the last number dialled.
4
All manuals and user guides at all-guides.com
Forwarding a call from the headset to the con-
nected mobile phone:
Press and hold the – button (2) for about 2 seconds to
forward a call from the headset to the mobile phone. To
forward the call back to the headset, once more press
and hold the – button (2) for about 2 seconds.
5.5 Disconnecting the headset
Turn off the headset by pressing and holding the
multifunction button (1) for about 6 seconds.
5.6 Battery level
• An acoustic signal sounds and the display flashes in
• Charge the headset as described in 4. Getting
6. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents. Make
sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
8. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
red when the battery is low.
Started

Publicidad

Tabla de contenido
loading

Tabla de contenido