Worx WG708E Traducción De Las Instrucciones Originales página 10

Cortadora de cesped
Ocultar thumbs Ver también para WG708E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57
blade bolt and the blade
assembly are not worn or
damaged. Replace worn or
damaged blades and bolts
in sets to preserve balance.
Replace damaged and
unreadable labels.
d) Before use check the
supply and extension cord
for signs of damage or
aging. If the cord becomes
damaged during the use,
disconnect the cord from
the supply immediately.
DO NOT TOUCH THE CORD
BEFORE DISCONNECTING
THE SUPPLY. Do not use
the machine if the cord is
damaged or worn.
OPERATION
a) Operate the machine only in
daylight or in good artificial
light.
10
b) Avoid operating the machine
in wet grass.
c) Always be sure of your
footing on slopes.
d) Walk, never run.
e) Mow across the face of
slopes, never up and down.
f) Exercise extreme caution
when changing direction on
slopes.
g) Do not mow excessively
steep slopes.
h) Use extreme caution when
reversing or pulling the
lawnmower towards you.
i) Stop the blade(s) if the
lawnmower has to be tilted
for transportation when
Electric lawn mower
All manuals and user guides at all-guides.com
crossing surfaces other
than grass, and when
transporting the lawnmower
to and from the area to be
mowed.
j) Never operate the
lawnmower with defective
guards, or without safety
devices, for example
deflectors and/or grass
catchers, in place.
k) Switch on the motor
carefully according to
instructions and with feet
well away from the blade(s).
l) Do not tilt the lawnmower
when switching on the
motor, except if the
lawnmower has to be tilted
for starting. In this case,
do not tilt it more than
absolutely necessary and lift
only the part which is away
from the operator.
m)Do not start the machine
when standing in front of the
discharge.
n) Do not put hands or feet
near or under rotating parts.
Keep clear of the discharge
opening at all times.
o) Do not transport the
lawnmower while the power
source is running.
p) Stop the machine and
disconnect the plug from the
mains. Make sure that all
moving parts have come to
complete stop.
- Whenever you leave the
machine;
- Before clearing blockages or
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido