Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Fault
Excessive Vibration
Light on, but motor
does no work.
Both light and motor
do not work.
Soction performance
reduced.
Works normally but
cooking smeels
linger.
Note: If the lamp is failed please contact the after-sales care.
Cause
The appliance is not installed
properly on the brackets.
The fan Blade is damaged.
The fan motor is not fixed
tightly.
The fan Blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose
Speed may be too low.
Distance between the cooker
Hood and the hob is too great.
Aluminium grease filter is dirty.
Top vent might be obstructed.
The activated carbon filter may
be misplaced.
Charcoal filter not fitted in
recirculation mode or charcoal
filter is full of grease.
Solution
Take down the appliance and check
it is properly fixed.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
Replace with a bulb with correct
rating.
Check power supply.
Select a higher speed.
Readjust the distance to:
Gas hobs: 750mm
Electric hobs: 650mm
Clean filters. See Care and
maintenance section.
Clear any obstruction.
Ensure that the carbon filter is
installed according to the
manufacturer instructions.
Fit charcoal filter if recirculating or
change the filter. See Care and
maintenance section.
41
Publicidad
Tabla de contenido
