Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING
All installation work must be carried out by a competent person or qualified
electrician.
Before connecting the mains, supply ensure that the mains voltage
corresponds to the voltage on the rating plate.
WARNING: THIS APPLIANCE MUST NOT BE EARTHED.
Mains Supply could be connected to the Mains Voltage by Direct Connection.
Direct Connection
If the appliance is being connected directly to the mains an omnipolar circuit breaker must be
installed with a minimum opening of 3mm between contacts.
The installer must ensure that the correct electrical connection has been made and that it
complies with wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it
must be replaced by a special cord or assembly available from the Manufacturer declines all
liability for damage caused to persons and objects due to incorrect or improper installation of the
appliance.
Electrical Requirements
Any permanent electrical installation must comply with the latest local legal requirements and
local power company regulations. For safety, electrical installation should be performed by a
qualified electrician or contractor.
Electrical Connection
Before connecting the mains supply ensure that the mains voltage corresponds to the voltage on
the rating plate inside the appliance.
43
Publicidad
Tabla de contenido
