Manual Code Search - One for All OARN08G Guia Del Usuario

All manuals and user guides at all-guides.com

Manual Code Search

The Manual Code Search takes you one-by-one through all the
codes for the device you're trying to control. When you find the one
that operates your device, you stop the search and store that code.
TIPS: The Manual Code Search method may take a long time
Code Entry method.
them to a device type. See the Assigning the AUX1 and AUX2
Keys section.
1.
Manually turn on the device you want to control.
2.
Press and hold the device key you want to program (the
POWER key illuminates). While you're holding down the
device key, use your other hand to press and hold the
remote's POWER key at the same time (the POWER key
turns off).
3.
Wait until the remote's POWER key comes on and stays on.
Then release both keys.
4.
Point the remote directly at the front panel of the device you
want to control. Press SKIP FWD on the remote and wait 2
seconds. The remote is testing a single code for your device.
Did your device turn off?
YES: Press the OK key to store the code. You're done!
You've programmed this device key.
NO: Press SKIP FWD again. The remote tests the next code
for your device.
Keep pressing SKIP FWD every 2 seconds until your device turns
off. When it does, press OK.
TIP:
7