One for All OARN08G Guia Del Usuario página 5

All manuals and user guides at all-guides.com
3.
Press and hold the device key you want to program (the
POWER key illuminates). While you're holding down the
device key, use your other hand to press and hold the
remote's POWER key at the same time (the POWER key
turns off).
4.
Wait until the POWER key comes on and stays on. Then
release both keys.
5.
Look at the numbers you circled for your device's brand
code. Press those numbers on the remote keypad.
Note:
6.
Point the remote directly at the front panel of the device
you want to control. Press SKIP FWD on the remote and
wait 2 seconds. The remote is testing a single code for
your device's brand.
Did your device turn off?
YES: Press the OK key to store the code. You're done!
You've programmed this device key.
NO: Press SKIP FWD again. The remote tests the next code
for your brand.
Keep pressing SKIP FWD every 2 seconds until your device
turns off. When it does, press OK.
NOTES:
to keep the remote pointed at the IR sensor of the device you
are currently programming the remote to control.
four times and the last programmed code under that device
search method.
Testing the Code for Maximum Functionality
1. Try a variety of the device's functions with the remote. If
some device features don't work, go to the next step to try
a different code.
2. Repeat the Brand Code Search from the beginning. When
the device turns off for the first time, don't press the
OK key, which would store the same code. Instead, with
the unit now off, continue to press the SKIP FWD key
repeatedly until the unit turns back on.
3. Once the unit turns back on, you have found another code
that operates the device. Press the OK key.
4. Test the key's functionality again by attempting to control
a variety of the device's functions. If the code that has
been stored controls the majority of the device's functions,
programming is complete. If the code stored does not give
maximum functionality, try another code.
5