Battery Chargers - Black and Decker BCPC20 Manual De Instrucciones

ENGlIsh
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or direct
current
...................... Class II Construction
(double insulated)
n o ....................... no load speed
Read the manual prior to operation.
Always remove the battery from the
appliance before performing any cleaning or
R
maintenance.
Do not expose the appliance to rain or high
humidity.
Never direct the water jet at people,
animals, the machine or electric
components.
IMPORTANT SAFETY INSTRUCTIONS FOR

BATTERY CHARGERS

save these instructions: This manual contains important
safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using
battery pack.

WARNINGS! Shock hazard. Do not allow any liquid to
get inside charger.

CAUTION: Burn hazard. To reduce the risk of injury,
charge only designated BLACK+DECKER batteries. Other
types of batteries may burst causing personal injury
and damage.

CAUTION: Under certain conditions, with the charger
plugged in to the power supply, the charger can
be shorted by foreign material. Foreign materials
of a conductive nature such as, but not limited to,
steel wool, aluminum foil, or any buildup of metallic
particles should be kept away from charger cavities.
Always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug
charger before attempting to clean.

WARNINGS!:
Do not attempt to charge the battery pack
•
with any chargers other than the ones in
this manual. The charger and battery pack are
specifically designed to work together.
26
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye protection
..................... wear hearing
protection
..................... read all
documentation
• These chargers are not intended for any
uses other than charging designated
BLACK+DECKER rechargeable batteries. Any
other uses may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when
disconnecting charger. This will reduce risk of
damage to electric plug and cord.
• Make sure that cord is located so that it will
not be stepped on, tripped over, or otherwise
subjected to damage or stress.
• Do not use an extension cord unless it is
absolutely necessary. Use of improper extension
cord could result in risk of fire, electric shock, or
electrocution.
• An extension cord must have adequate wire
size (AWG or American Wire Gauge) for safety.
The smaller the gauge number of the wire, the
greater the capacity of the cable, that is 16 gauge
has more capacity than 18 gauge. When using more
than one extension to make up the total length, be
sure each individual extension contains at least the
minimum wire size.
Voltage
Total length of cord in meters (m)
(Volts)
120-127V 0-7
220V 0-15
Rated
Minimal cross-sectional area of the
Ampere
Range
0-6A 1,0
6-10A 1,0
10-12A 1,5
12-16A 2,5
• Do not place any object on top of charger or place
the charger on a soft surface that might block the
ventilation slots and result in excessive internal heat.
Place the charger in a position away from any heat
source. The charger is ventilated through slots in the top
and the bottom of the housing.
• Do not mount charger on wall or permanently affix
charger to any surface. The charger is intended to use on
a flat, stable surface (i.e., table top, bench top).
• Do not operate charger with damaged cord or plug —
have them replaced immediately.
• Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way. Take
it to an authorized service center.
• Do not disassemble charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution or fire.
7-15 15-30
15-30 30-60
cord in milimeters (mm )
2
1,5 1,5
1,5 2,5
1,5 2,5
4,0 Not recommended
30-50
60-100
2,5
4,0
4,0