Product Set Up; Product Use; Base Installation - Joie signature calmi Manual De Instrucciones

WARNING
!
CAREFULLY read the warnings given in the separate Safety Manual
to ensure a secure usage of the product.

Product Set Up

see images -
1 3
!
This enhanced child restraint system is only suitable for vehicle seats
equipped with ISOFIX anchorage points.
!
DO NOT install this enhanced child restraint on vehicle seats that
face sideways or rearward with respect to the moving direction of the
vehicle.
!
Please refer to your vehicle owner's manual for recommended or
suggested installation positions.
!
This enhanced child restraint must be installed on the rear vehicle
seat.
3
!
DO NOT install this enhanced child restraint on movable vehicle
seats during installation.

Product Use

Base Installation

see images -
4 8
1. Attach the ISOFIX guides to the vehicle's ISOFIX anchor points (see
vehicle owner's manual).
surface of the vehicle seat from being torn. They can also guide the
ISOFIX connectors.
2. Unfold the load leg from storage compartment.
5
1
2
The ISOFIX guides can protect the
4
5
3. Press the ISOFIX adjustment button to adjust the ISOFIX
connectors. Line up the ISOFIX connectors with the ISOFIX guides,
and then click both ISOFIX connectors into the ISOFIX anchor
points.
6
!
Make sure that both ISOFIX connectors are securely attached
to their ISOFIX anchor points. There should be two audible
clicks and the colors of the indicators on the both ISOFIX
connectors should be completely green.
!
Check to make sure the base is securely installed by pulling on
the both ISOFIX connectors.
4. After placing the base on the vehicle seat, extend the load leg to
floor . When the load leg is installed correctly, the load leg
7
indicator will show green. Red will be shown when installed
incorrectly. -2
7
!
The load leg has multiple positions. When the load leg
indicator shows red this means the load leg is in the wrong
position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg adjustment button, then shorten the load
leg upwards. -1
7
5. The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
ISOFIX anchor points.
8
6. To remove the base from the vehicle seat, push the secondary lock
buttons -1 first and then press the ISOFIX releasing buttons
9
-2 on the ISOFIX connectors before removing the base from the
9
vehicle seat.
9
7. For transporting, press ISOFIX adjustment button and move the
ISOFIX connectors back into the storage position.
-3
6
8
-1
10
6