Mower Belt Replacement; Leveling The Mower - Simplicity Conquest Serie Manual Del Operador

MAINTENANCE

Mower Belt Replacement

PTO BELT REPLACEMENT
1. Park the tractor on a smooth, level surface such as a
concrete floor. Disengage the PTO, turn off the engine
and lock the parking brake. Remove the key. Lower
the mower to its lowest position.
2. Remove the left and right mower belt covers.
3. Move the idler arm release lever (A, Figure 23) to
relieve belt tension. Remove the PTO belt (B) from the
engine PTO clutch pulley (C).
4. Remove the old belt and replace with a new one.
Make sure the belt is seated in the pulley grooves.
5. Move the idler arm release lever to release tension on
the PTO belt and install on the engine PTO pulley and
mower PTO pulley (D) as shown.
6. Reinstall the right and left belt covers.
7. Run the mower under a no-load condition for about 5
minutes prior to using.
ARBOR DRIVE BELT REPLACEMENT
Replacement of the arbor drive belt (E, Figure 23)
requires the idler pulley tensioning spring to be released.
See you local authorized servicing dealer for this repair.
28
C
Figure 23. PTO Belt Replacement

Leveling the Mower

If the cut is uneven, the mower may need leveling.
Unequal or improper tire pressure may also cause
an uneven cut. Make sure tire pressure is correct
as specified in Checking Tire Pressure. See Setup
Instructions.
E
A
D
B