Siemens SIPART PS2 Manual De Instrucciones página 10

Description
Dimensions in mm
A Mounting on a yoke with fin
B Mounting on a yoke with plane surface
C Mounting on a yoke with columns
①
NAMUR mounting bracket IEC 60534 - not
included in the scope of delivery
Figure 4-2 Example of the assembly on a linear actuator with a stroke up up to 14 mm (0.55 inch)
Procedure
1. Produce the mounting panel
2. Align the sensor to the center of the stroke. Observe the dimensions specified in the figure.
Reference
For information on the scope of delivery, refer to chapter "Scope of delivery of NCS for linear actuators up to 14 mm
(0.55 inch) . (Page 18)".
4.3 Mounting the NCS to a linear actuator > 14 mm (0.55 inch)
Prerequisites
1. An EMC filter module in the positioner.
2. An NCS for linear actuators > 14 mm (0.55 inch) 6DR4004-.N.30.
3. Linear actuator with interface to NAMUR
Order no. based on the respective stroke range: 6DR4004-8V or 6DR4004-8V + 6DR4004-8L.
Or
10
All manuals and user guides at all-guides.com
②
③
④
⑤
② ⑤
and mounting bracket
Assembly panel for Non Contacting Sensor (NCS) -
individual solution; not included in the scope of delivery
Non Contacting Sensor (NCS)
Magnet
Mounting bracket for the magnet - individual solution;
not included in the scope of delivery
individually.
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-09, 09/2014