Siemens SIPART PS2 Manual De Instrucciones página 9

Magnet holder made of glass fiber reinforced polyester
1. Insert the plastic washer
④
2. Fix the magnet
④
magnet can now be rotated easily on the clamping
table ⑨.
3. Slide the tensioning ring
sure that the spring elements
⑤
hooks on the magnet ④ and that they engage. You
will now have more resistance when turning the
①
tensioning ring and magnet ④.
⑬
4. Screw the NCS onto the mounting console
⑫
.
⑬
5. Once the NCS is mounted, the clearance of 3 mm between the top edge of the magnet
⑩
mounting console is set automatically.
Procedure for part-turn actuators with manufacturer-specific interface
1. Steps 1 to 4 as above.
2. Set a clearance of 3 mm between the top edge of the magnet
the stub shaft accordingly, or insert washers underneath the NCS housing
Reference
For information on the scope of delivery, refer to chapter "Scope of delivery of NCS for part-turn actuators (Page 18)".
4.2 Mounting the NCS to a linear actuator up to 14 mm (0.55 inch)
Requirements
1. An EMC filter module in the positioner.
2. An NCS for linear actuators up to 14 mm (0.55 inch) 6DR4004-.N.20.
3. Linear actuator with interface to NAMUR. This installation must be carried out individually. Only a NAMUR mounting
bracket can be used as mounting base. The following figure shows the assembly with NAMUR mounting bracket.
Or
linear actuator without interface to NAMUR and individual mounting solution.
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-09, 09/2014
All manuals and user guides at all-guides.com
⑥ ④
into the magnet
⑨
onto the clamping table . The
① ④
over the magnet
③
are located above the
⑩
using the hex nut
Magnet holder made of anodized aluminum
. 1. Place the magnet
2. Secure the magnet
connecting the two parts of the tensioning ring
the two hex socket head screws
can now be rotated easily on the clamping table ⑨.
. Make
3. Then tighten the two hex socket head screws
④
magnet can then no longer be rotated on the
clamping table
⑪
, the washer
④
and the top edge of the mounting console
⑬
.
④
onto the clamping table
④
to the clamping table
②
. The magnet ④
⑨
.
⑧
, and the hexagon socket screw
④
and the top edge of the
⑨
.
⑨
by
①
to
②
. The
⑩
. Extend
9