Fastening The Rotor Blades; Flight Operation - Carson AIRBEAST II PRO Manual De Instrucciones

Equilibrating the model
The helicopter must be correctly balanced. If there is an incorrect
location of the centre of gravity, you lose the control over the model!
The location of the centre of gravity of the model is preset.
Corrections are only necessary if you are not satisfied with the
flight characteristics.
The centre of gravity of the helicopter-model should lie exactly in
the rotation point of the rotor axis.
Shift the airplane battery in order to determine the optimal location of
the centre of gravity.
• Hang the helicopter on the upper rotor head, in the extension
of the axis of rotation. The helicopter may not tip forwards or
backwards, no matter in which position the principal rotor blades
are located.
• If the nose drops, then the model is top-heavy. Shift the airplane
battery slightly backwards.
• If the tail sinks, shift the airplane battery forward in order to adjust
the centre of gravity.
Secure the airplane battery when you have determined the optimal
location of the centre of gravity.

Fastening the rotor blades

The rotor blades must be able to align themselves 180° to each other
solely by the centrifugal force.
Therefore check the seating of the retaining screws (a) of the rotor
blades:
The screws may only be tightened firmly enough that the rotor blades
still fold downwards when you tip the helicopter to the side.
h. Flight Operation
Switching on the model
Ensure sufficient space in order to undertake the first flight
experiments. Even if the indoor helicopter can later be flown in the
smallest quarters, it requires about 3 m free space in all directions.
• Set the model on a smooth and level surface, so that the helicopter
can freely glide and lift off.
• Set the helicopter about 2 m in front of yourself on the ground, the
tail pointing towards you. This way the direction of reaction of the
helicopter conforms to the direction of control.
• Pull the transmitter antenna totally out. The effective range of the
remote control is reduced if the antenna is not completely pulled
out.
• Pull the left remote control lever (pitch) totally back.
• Take care that the pitch function of the trim lever is approximately
in the middle position.
• Switch the transmitter on.
• Now connect the charged airplane battery to the receiver.
All manuals and user guides at all-guides.com
orrect
model!
he
ctly in
location of
ension
ds or
or blades
Lateral equilibration
• Support the helicopter at the end of the tail beam and front on the
longitudinal axis as far as possible. To do this, remove the cabin
hood. The helicopter may not tip to one side, no matter in which
position the principal rotor blades are located.
CARSON Helicopter Airbeast II Pro
G GB
a
37