Sauder Library 158085 Instrucciones De Montaje página 8

5
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
You may notice a separation of the plastic and a "popping" noise while
tightening the FASTENER. These are both intended design features.
- Position the TOP (C) as shown.
NOTE: Be sure the long finished edge is facing up.
- Fasten the RIGHT END (A) to the TOP (C). Tighten the TWIST-LOCK
NOTE: Be sure the finished edge of the RIGHT END is facing up.
- Fasten the SHELF (D) and BOTTOM (E) to the RIGHT END (A). Tighten the TWIST-LOCK
the SHELF and BOTTOM.
NOTE: Be sure the indicated holes are in the location shown. Follow the diagram.
158085
All manuals and user guides at all-guides.com
Long
finished
edge
RIGHT
TOP (C)
END (A)
hole of the adjoining part while locking the FASTENER.
www.sauder.com/services
SHELF (D)
These holes
should be here.
R FASTENER (Refer to the enlarged diagram.)
R
Tighten the FASTENER as tight
as possible after inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
BOTTOM (E)
FASTENERS in the RIGHT END.
R
FASTENERS in