Metabo HPT DH3628DD Instrucciones De Seguridad Y Manual De Instrucciones página 12

English
Clean out the dust in the fi lter chamber (Fig. 22)
In addition, clean off all dust attached to the surface of
the fi lter.
NOTE
Do not directly touch the fi lter with a hard brush or
similar tool, or blast the backside of the fi lter with
compressed air.
Also, do not wash the fi lter with water.
Doing so may scratch the fi lter and/or shorten its life.
(4) Make sure the fi lter is positioned correctly.
(5) Attach the dust box to the dust housing. (Fig. 23)
Cylindrical protrusion
Dust box
NOTE
Make sure there is no dust attached to the latch before
fi tting the latch.
Failure to do so may result in the dust box falling off
during use.
12
Fig. 22
Round cavity
Dust housing
Fig. 23
6. Replacing the fi lter
If the fi lter inside the dust box becomes clogged, the
dust extraction performance declines.
As a guideline, replace the fi lter after every 100 times
that the dust box becomes full.
WARNING
When replacing the fi lter, in order to prevent an
unlikely accident, be sure to turn off the tool's
switch and remove the battery from the tool
body.
(1) Insert a fl at-head screwdriver into each of the four
catches of the fi lter cover and remove the cover.
(Fig. 24)
Catch (fi lter cover)
Filter cover
(2) Remove the fi lter from the inside and relace it with a
new fi lter. (Fig. 25)
(3) Attach the fi lter cover.
Fig. 24
Filter (internal)
Fig. 25