Transport And Installation - BIEMMEDUE WET 400 Serie Manual De Uso Y Mantenimiento

produced. In the event of abnormal vibrations, the operator
should immediately stop the machine and contact maintenance
personnel.
4.5 Degree of protection of machines (IP)
Degree of protection against solid objects (protected
against dust)
Degree of protection against water (protected against
splashes of water)
4.6 Admissible environmental values
Admissible environmental values
Admissible operating
temperatures
Variations in ambient
temperature
Relative humidity range
Vibrations
The machine may also be operated out of doors providing the
surface is asphalted, concreted or similar and dry.
The machine may not be used in areas with an
explosive atmosphere.
components or equipment designed to operate in
explosive atmospheres must be indicated with the
(ATEX) mark in accordance with EN 60079-14 (CEI 31-
33) "electrical
atmospheres with the presence of gas.
4.7 Guards
All dangerous areas are closed with guards and protective devices
fixed to the chassis with screws making all hazardous areas
inaccessible to the operator. There is one removable guard, the tank
lid, but this does not give access to any dangerous components of
the machine.
4.8 Safety devices
The machine is not fitted with an independent lighting system.
5

Transport and installation

5.1 Lifting and handling
IMPORTANT - Follow the instructions below.
The machine is delivered from the Manufacturer on a pallet in
special cardboard packaging. Before unpacking, the machine can
be transported and handled by means of a lift truck with a capacity
of at least 200 kg.
Straps
Crate
3
3
-10° C - 50° C (50° F - 113°
F)
Max. 1.1° C / Min (Max 2° F /
Min)
75% or less
≤ 0.5 G
Machines and relative
constructions for explosive
1.
2.
3.
Pallet
To unpack the machine, remove the straps holding the cardboard
box to the pallet and remove the box. The machine rests on the
pallet used for transport with the handlebar folded down onto the
machine itself. Grip and rotate the knobs/handgrips towards you to
rotate the handlebar shaft and bring it into the vertical.
The weight of the machine allows it to be lifted easily by two people.
A number of safety instructions relating to transport are given below.
5.2 Installation
IMPORTANT - Before proceeding with installation
read the following warnings carefully.
Failure to observe the following warnings could
cause injury, death or damage to equipment.
The 400 BA is delivered without batteries.
ordered together with the machine, they will already be mounted and
checked by the Manufacturer or dealer.
If this is not the case, the customer must obtain 2 x 12 V 80 Ah batteries
(with relevant 24V and 10A battery charger) and perform the following
operations.
Open the tank lid;
•
Remove the tanks one at a time, lifting the back first and
•
using the handle provided.
Once the tanks have been extracted, remove the crossbar
•
they rest on;
Remove the plastic battery compartment cover;
•
GB
If the batteries were
Tank
Tank crossbar