BIEMMEDUE WET 400 Serie Manual De Uso Y Mantenimiento página 24

GB
Remove the lubricants (oils and greases) from the speed
variators. To remove these substances, read the
instructions in the maintenance section. Lubricants
must be disposed of in conformity with current
legislation. Under no circumstances may they be
disposed of in
accumulators (buffer batteries, dry batteries etc) from
the machine. The accumulators removed must be
disposed of according to current legislation.
Remove and
identification plates and any other documentation
relevant to the machine (manuals, diagrams etc).
9.2 General regulations on the disposal of
industrial waste.
As different regulations are applicable in the various countries, the
legal requisites in the country concerned should be followed.
9.3 Company refuse management
The following instructions do not apply if the holder
of the refuse is a private individual.
Anyone who, in the course of his or her business
activities, is in possession of exhausted vegetable
and animal oils or fats while waiting to confer them
to the consortium is obliged by law to store them in
a special container in compliance with current
waste disposal legislation.
10 Table of regular maintenance
OPERATION
Check the functioning
X
of all controls
Check the battery
X
fluid
X
Charge the batteries
Clean the filter
Replace the belts
Check belt tension
Check the tightness
of screws and nuts
Check the condition
of the brushes
Check the condition
of the squeegees
the environment. Remove
subsequently destroy machine
X
X
X
X
X
X
X
X
11 Troubleshooting
The table below gives the most common problems which may arise
during normal use of the 400 BA and 400 EL FLOOR CLEANERS.
These problems are easy to resolve with operations classified as
routine maintenance. If the problem is not present in the following
the
table or cannot be eliminated following the instructions here, contact
an authorised service centre.
PROBLEM
The water-detergent
solution is
delivered
Squeegee does not
suck up the water
The brush does not
turn
CAUSE
Empty tank
not
Pump off
Pump cable
interrupted - clogged
Pump damaged
The squeegee is not
adjusted correctly
The squeegees are
worn
The suction pipes
are blocked
The suction pump is
damaged
The brush is broken
Electrical or
mechanical problem
SOLUTION
Fill the tank
Press the pump start
button
If blocked, clean the
cable or contact an
authorised service
centre
Contact an
authorised service
centre
Adjust the height of
the squeegee
Replace the
squeegees
Clean the pipes
Contact an
authorised service
centre
Replace the brush
Contact an
authorised service
centre