Viewing The Water Litre Counter; Tips For A Good Cup Of Coffee; Maintenance And Cleaning; Safety Precautions - Astoria Storm SAEP Manual De Uso Y Mantenimiento

7.8 Viewing the WATER LITRE COUNTER

To view the machine's wa-
ter consumption and the
water softener regenera-
tion threshold, proceed as
follows:
• Select the button.
• Press the menu button
.
• Select the configura-
tion button .
• Press the
Water filters
button.
• When the water con-
sumption exceeds the
set value, the system
displays the automatic
water softener regen-
eration warning.
• If the threshold value
is set to zero, the re-
generation warning is
not displayed.
To reset the
counter list,
contact the
Technician.

7.9 Tips for a good cup of coffee

Wash the filters and filter holders on a daily basis, as indicat-
ed in para. 8.9.2 on page 59. The failure to perform this
cleaning operation will negatively affect the quality of the
dispensed coffee.
To obtain high-quality coffee, it is important that the water
hardness does not exceed 6-7°f (French degrees). If the water
hardness exceeds these values, it is advisable to use a water
filter or softener. Avoid using a water softener if the water
hardness is less than 4°f.
If the taste of chlorine in the water is particularly strong, in-
stall a special filter.
Do not to keep large amounts of coffee beans on hand. If you
change the type of coffee, we recommend calling out the Tech-
nician to adjust the water temperature and coffee grinder.
If the machine has not been used for a certain period of time
(2-3 hours), carry out a few dry runs. Make sure that the machine
is constantly cleaned and periodic maintenance is carried out.
56 216
of
USER MENU
Programme
Last dispensed
Parameters
doses
beverage
Set the date
Washes
and time selection
Water filters
Screensaver Counter list
WATER FILTERS
Regeneration threshold
Water consumption

8. MAINTENANCE AND CLEANING

8.1 Safety precautions

Carefully read the instructions provided in
chapter "I. SAFETY PRECAUTIONS" on page
33.

8.2 Periodic maintenance

Besides carrying out maintenance activities according to
the frequency specified in the "Periodic maintenance table",
a general inspection must be carried out on the machine at
least once a year by a Technician.
8.3 Maintenance after a short period of
machine inactivity
"Short period of machine inactivity" refers to a period of time
exceeding one working week.
If the machine is switched back on after this period, the Tech-
nician must replace all the water inside the hydraulic circuits
as indicated in para. "8.2 Periodic maintenance".
Furthermore, all periodic maintenance operations must be
carried out, see the previous paragraph.
Recipe
Component problems highlighted in grey require
the machine to be switched off and the Technician
to be called out.
8.4
0 lt

8.5 Malfunctions and solutions

263 lt
The machine provides the user with important messages re-
garding its operating status.
Messages regarding the alarms that may occur during opera-
tion are displayed on the bottom of the screen.
In the "Malfunctions and Solutions Table", alarms and actions
to carry out in order to try and resolve the reported problem
are provided.
Problems highlighted in grey require the machine
to be switched off and the Technician to be called
out.
If the malfunction cannot be resolved or an alarm
signal has appeared on the display, turn off the
machine off and call out the Technician.
USER Manual