Specification; Description - Sabo CS-25 Manual Del Operador

1

SPECIFICATION

Product description
Type
Motor
Chain speed
Chain stop time
Capacity of saw chain lubricant
Guide bar length
Weight without battery (with 250 mm guide bar)
Weight without battery (with 350 mm guide bar)
Battery
Charger
Guide bar 250 mm / Chain 250 mm
Guide bar 350 mm / Chain 350 mm
Measured sound pressure level
Guaranteed sound power level
Vibration
WARNING
The hand-arm vibrations from actually using the tool may deviate from the stated value. This depends on the how the tool is used. Avoid the danger of vibrations with the following
precautionary measures: wear gloves when using it, limit the period of use and shorten the application time.
2

DESCRIPTION

see figure 1 to 22
1 Guide bar cover
2 Front handle guard / chain brake
3 Front handle
4 Safety lock button
5 Switch trigger
6 Oil tank cap
7 Oil level gauge
8 Spike bumpers
9 Saw chain
10 Guide bar
11 Wrench
12 Rear handle
13 Chain adjustment screw
14 Chain cover
15 Chain cover nuts
16 Bolt for saw chain tension
17 Sprocket
18 Battery release button
19 Oil outlet
20 Bar groove
21 Chain drive links
22 Cutter
23 Felling direction
24 Hazard zone
25 Escape route
26 Direction of fall
27 Notch
28 Directional notches
29 Hinge
30 Limb cut
31 Work on the ground, while leaving the lower branches to provide support until the log is cut
32 Log supported along the entire length
33 Cut from top (over buck) avoid cutting into the ground
34 Log supported on one end
35 Under buck
36 Over buck
37 Log supported at both ends
38 Bucking a log
39 Stand on uphill side when cutting because log may roll
40 Relief cut
41 Bucking cut
Chainsaw
SA561521
40 V brushless dc motor
20 m/s
< 0.2 s
180 ml
250 mm, 350 mm
3.65 kg
3.75 kg
SAU15032
SAU16450 / SAU16451
SAU17028 / SAU17029
SAU15033 / SAU16509
SAU17061 / SAU17058
SAU17062 / SAU17060
L = 92.0 dB(A) k = 3 dB(A)
PA
L = 104 dB(A)
WA
a = 4.9 m/s k = 1.5 m/s
2 2
h