Transport And Storage Of The Chainsaw; Environmental Protection - Sabo CS-25 Manual Del Operador

ADDING BAR AND CHAIN LUBRICANT
Check the oil quantity in the machine using the oil indicator (7) or by looking in the opened tank. If the oil level is too low, add bar and chainsaw lubricant as follows.
IMPORTANT
Use only the bar and saw chain lubricant that is recommended by the manufacturer.
NOTE
The machine is delivered from the factory without bar and chain lubricant.
·
Loosen and remove the lid of the oil tank (6).
·
Add oil to the oil tank.
·
Monitor the oil indicator (7) to ensure that there is no dirt in the oil tank while you add oil.
·
Place the lid on the oil tank (6).
·
Tighten the lid of the oil tank.
·
A full oil tank can be used for 20 to 40 minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. This can cause damage to the guide bar or chain.
11

TRANSPORT AND STORAGE OF THE CHAINSAW

Before moving the machine, you should always
·
Remove the battery from the machine.
·
Keep hands clear of the safety lock button.
· Put the scabbard on the guide bar and the chain.
Before storage of the machine, you should always
·
Remove the battery from the machine.
·
Remove any unwanted material from the machine and clean.
·
Make sure that the storage area
Is out of the reach of children.
o
Is free of corrosive substances such as garden chemicals and de-icing salts.
o
·
Put the scabbard on the guide bar and the chain.
·
Keep an unused battery away from paperclips, coins, keys, screws, nails and all other objects that could connect the contacts.
·
A short circuit of the battery can cause burning or fires. Store the battery in a dry place and at a temperature below 27°C.
·
Never store discharged batteries. A battery that is too warm must be allowed to cool before charging.
·
The battery's charge will diminish during storage. The higher the temperature, the faster the discharge. Recharge the batteries monthly if they are being stored for a longer period. This
increases the life and maintains performance.
·
Remove the battery from the device before adjusting settings, replacing accessories or after use. This prevents the risk of your device being switched on inadvertently or unsupervised.

ENVIRONMENTAL PROTECTION

·
Environmental protection should be an essential and prioritised aspect when using the machine. Do not disturb your surroundings when using the device.
· Strictly observe the local provisions for disposal of the packaging, oil, petrol, filters, damaged parts or all other polluting materials. These materials must not be disposed of with
domestic waste, but instead must be collected separately and disposed of at a recycling site that recycles the materials.
·
Strictly observe the local provisions for disposal of the cut waste.
If decommissioning the machine, it must not be simply disposed of in the environment, but instead must be disposed of at a recycling site according to the local provisions.