Titan T8000 Guia Del Usuario página 45

WARNING
Always turn off and unplug the vacuum cleaner before performing maintenance to the
PROBLEM
The plug is not plugged to
the wall outlet.
Vacuum cleaner Tripped circuit breaker /
will not start. blown fuse at household
service panel.
Loose hose electrical
connections.
Full or clogged dust cup.
passages.
Wrong pile height setting.
Electronic suction control
is in low power position.
dirt pick-up is
Hole in hose.
poor or suction
Worn nozzle agitator.
power is weak.
Worn or broken belt.
Dirty agitator or end caps.
Dust cup is installed
incorrectly.
TROUBLESHOOTING
POSSIBLE CAUSE
Be sure the power cord plug is fully plugged
into outlet. Move switch to HARDFLOOR or
CARPET position.
Reset circuit breaker or replace fuse.
Reconnect hose ends (page 9-10).
Empty and clean the dust cup (page 25-27).
14).
Replace the hose.
Change the agitator (page 33-44).
See BELT CHANGING AND AGITATOR
CLEANING (page 33-43).
See BELT CHANGING AND AGITATOR
CLEANING (page 33-43).
See EMPTYING DUST CUP (page 25-27).
-45-
SOLUTION