Titan T8000 Guia Del Usuario página 46

Dust cup lid and dust cup
misassembly.
Wrong hose or hood
electrical connections.
Vacuum cleaner Tripped overload
starts but shuts protector in the motorized
off. nozzle.
Tripped thermal protector
in canister.
Nozzle connections
unplugged.
Worn or broken belt.
Motorized Dirty agitator or end caps.
nozzle will
not run when
Tripped overload
attached.
protector in the motorized
nozzle.
Switch not in CARPET
position.
Vacuum
Wrong pile height setting.
cleaner picks
up moveable
rugs or nozzle
Suction too strong.
pushes too
hard.
See PRE-FILTER CLEANING (page 28-29).
Check connections; reconnect hose ends
(page 9-10).
Turn off the vacuum cleaner and remove any
restart the vacuum cleaner. If the vacuum
cleaner starts and stops again, clean the
agitator and end caps, then reset (page 22).
See THERMAL PROTECTOR (page 22).
See BELT CHANGING AND AGITATOR
CLEANING (page 33-43).
See BELT CHANGING AND AGITATOR
CLEANING (page 33-43).
Turn off the vacuum cleaner and remove any
restart the vacuum cleaner. If the vacuum
cleaner starts and stops again, clean the
agitator and end caps, then reset (page 22).
Move the switch to CARPET position (page
13-14).
decrease suction (page 14).
-46-