Husqvarna CT 36A/A-V Manual De Usuario página 38

Maintenance
Clean the air filter.
Lubricate the blade shafts.
Lubricate the blade pitch cable and other parts of the
product.
Replace the engine oil.
Replace the air filter.
Do a check of the engine speed.
Do a check of the oil level in the gearbox.
Examine the belt for damage. Replace the belt if it is
necessary.
Examine and clean the spark plug. Replace the spark
plug if it is necessary.
Clean the fuel valve on the carburetor.
Clean the spark arrestor screen on the muffler.
Clean the sediment cup.
Drain the fuel and clean the fuel tank and the fuel filter.
Clean and adjust the carburetor.
To clean the product
CAUTION:
washer to clean the product.
• Use water and a brush to clean the product.
CAUTION:
directly at the fuel tank cap, electrical
components or the engine.
• Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
• Remove grease and oil from the handle.
To do a check of the engine oil level
1. Remove the oil tank cap and dipstick.
2. Clean the oil from the dipstick.
3. Put the dipstick back fully into the oil tank.
4. Remove the dipstick.
5. Examine the oil level on the dipstick.
6. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 44 or the engine manual for the correct
type of oil.
38
Do not use a high-pressure
Do not point the water
Technical data
Before use, After the
each 10 h first 20 h
X X
X X
X
O
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING:
directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
1. Loosen the oil drain hose from the holder.
2. Put a container below the oil drain hose. (Fig. 50)
3. Remove the plug from the end of the oil drain hose.
4. Tilt the product and let the oil run out into the
container.
5. Install the plug in the oil drain hose.
6. Install the oil drain hose in the holder.
7. Fill with new engine oil. Refer to
page 44 or the engine manual for the correct type
of oil.
8. Do a check of the engine oil level.
Monthly, Yearly, each
each 200 h 500 h
*
X X
X
O
X X
X
O
O
O
O
O
O
Engine oil is very hot
Technical data on
1452 - 002 - 20.05.2022