Transportation, Storage And Disposal - Husqvarna CT 36A/A-V Manual De Usuario

Problem
The blade pitch system
does not operate cor-
rectly.
The belt wears too
quickly.
There is an oil leak at
the top of the gearbox.
There is an oil leak at
the gearbox main shaft
or the countershaft.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
WARNING:
is installed, remove it before transportation.
There is a risk that the floating disc falls off
and causes injury or damage.
Lift the product to move it shorter distances. For longer
distances, put the product on a transportation vehicle.
To fold the handle to transport position
CAUTION:
fully before you fold the handle. If the blade
pitch is not decreased, the blade pitch cable
42
Cause
The blade pitch cable is broken or
incorrectly adjusted.
1 or more of the blades do not move
correctly in the hub.
The slot screw is missing at the rear
of the handle.
The blade lift ring and/or the yoke
arm is broken or very worn.
The blade pitch control on the han-
dlebar is defective.
The pulley is incorrectly aligned.
The belt is damaged or of incorrect
type.
The clutch is defective.
The gearbox is defective.
The gearbox seal is worn.
There is a leak in the engine.
There is too much oil in the gearbox.
The shaft and/or the seal is worn.
The screws are loose.

Transportation, storage and disposal

Be careful during
If an optional floating disc
Decrease the blade pitch
Solution
Let an approved service center repair the product.
Remove the blades. Clean and lubricate all con-
tact surfaces.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
Replace the belt. Use only original Husqvarna
spare parts.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
Let an approved service center repair the product.
and the blade pitch control can become
damaged.
Note:
The handle cannot be folded on all models.
• Loosen the locking knob and fold the handle forward.
(Fig. 59)
To lift the product with lifting equipment
WARNING:
equipment has the correct dimension. The
type plate on the product shows the product
weight.
WARNING:
product. Make sure that the lifting bracket is
correctly installed and not damaged.
Make sure that the lifting
Do not lift a damaged
1452 - 002 - 20.05.2022