Brita On Tap Instrucciones De Uso página 4

STEP 1:
• Activate the digital display
On the left side of the BRITA On Tap water filter system
there is a battery slot, which can be opened with a coin.
Before first use, please remove the sticker from the
battery and place the battery back into the battery slot.
Press the reset button and the display countdown will
start to work.
STEP 2:
• Remove the aerator from your tap and choose
the appropriate adapter.
The BRITA On Tap comes with 5 different adapters
Choose the correct adapter for your tap (A / B/ C)
A
Apply the BRITA On Tap with adapter type C: 1. Remove the attachment nut from the water filter body. 2. Place the type C
adapter onto the water filter body and turn it about half a turn, attaching it loosely to the water filter body. 3. Push the water filter
system firmly against the tap and tighten the screws of the adapter evenly. 4. Tighten the attachment nut securely to the water
filter body - the installation is complete.
Initial operation. The BRITA On Tap water filter system has separate outlets for unfiltered and filtered water.
Turn the cold water on at your tap and you get
showered unfiltered water i.e. to rinse vegetables.
Turn the lever down for filtered water to be used for
drinking, washing fruit and vegetables and for cooking.
4-STEP Installation
C
B
STEP 3:
• Apply the BRITA On Tap with adapter type A/B:
Remove the attachment nut from the water filter body.
Screw the adapter onto the tap through the attachment
nut. Tighten the attachment nut securely to the water
filter body - the installation is completed.
STEP 4:
• Insert the filter cartridge into the system
Open the housing by rotating the cap anticlockwise.
Insert the new filter cartridge and close the system by
rotating the cap clockwise until it locks.
Turn the lever up for unfiltered water in a straight beam
i.e. for washing hands or filling large water containers.
Caution: If the BRITA On Tap is new, the filter
cartridge may still contain material residue. This is
harmless to health and does not affect the perfor-
mance of your water filter. Run water through the filter
for 1 to 2 minutes to remove any residue. Please
repeat this process with every new filter cartridge. You
may use this water for your plants or it can be
discarded. If the BRITA On Tap has not been used for
more than 24 hours, allow water to pass for 30 to 60
seconds before using the filtered water.
4