Charging - Hella 8ES 004 417-251 Manual De Instrucciones

2. ChARgINg

For best possible charging of your batteries the voltage and current is adjustable. in addition to that temperature
compensated charging is selectable. See below how to set the parameters for customized charging.
1. Connect the charger cables to the charger
(see connect the cables)
2. Connect the charger to the battery
(see connect the cables)
3. Connect the charger to the wall socket
The power lamp will indicate that the mains cable is connected to the wall socket. The error lamp will indicate if
the battery clamps are incorrectly connected. The reverse polarity protection will ensure that the battery or
charger will not be damaged.
4. Press the MODE-button to select charging program
5. Press SET-button to set parameters
6. Select voltage
• Display (h) will indicate that voltage (
• Display (V) will indicate set voltage
• Press +/- to change
• Press SET-button to confirm
7. Select current
• Display (h) will indicate that current (
• Display (A) will indicate set current
• Press +/- to change
• Press SET-button to confirm
8. Select temperature compensation
• Display (h) will indicate that temperature compensation (
• Temperature sensor lamp will indicate activated temperature sensor
• Press +/- to change
• Press SET-button to confirm
9. Press the START/PAUSE-button to start charging cycle or press MODE-button to change charging
program
10. Follow the 8-step display through the charging process
The battery is ready to start the engine when STEP 4 is lit. The battery is fully charged when STEP 7 is lit.
11. Stop charging at any time by pressing the START/PAUSE-button
12. Press START/PAUSE-button to resume charging cycle
) is selectable
U
) is selectable
A
e ) is selectable
21